Signal Menu - Panasonic TH-85VX200W Operating Instructions Manual

Signal menu

Note:
"Signal" setup menu displays a different setting condition for each input signal.
3D Settings
Signal
Screensaver
Extended life settings
Input label
Network Setup
Component/RGB-in select
RGB
External scaler mode Off
Power save Off
PC Power management Off
Auto power off Off
OSD design Type1
OSD position Upper left
OSD Language English (UK)
Input signal display
Displays the frequency and the type of
the current input signal.
This display is valid only for
Component / RGB / PC and Digital input signal.
Display range:
Horizontal 15 - 110 kHz
Vertical 48 - 120 Hz
The dot clock frequency is displayed during digital signal input.
• 3D Y/C Filter
This menu is displayed when BNC Dual Video Terminal Board (TY-FB9BD) is installed to the unit.
On Off
Note:
When On, this setting only affects NTSC input signals.
• Colour system
This menu is displayed when BNC Dual Video Terminal Board (TY-FB9BD) is installed to the unit.
Auto PAL
Set the colour system to match the input signal. When "Auto" is set, Colour system will be automatically selected
from NTSC/PAL/SECAM /M.NTSC.
To display PAL60 signal, select "Auto" or "PAL".
If the picture image becomes unstable:
With the system set on Auto, under conditions of low level or noisy input signals the image may in rare cases
become unstable. Should this occur, set the system to match the format of the input signal.
• XGA Mode
This menu is displayed when the input signal is analog (Component/PC). This unit supports three types of XGA
signals with 60Hz vertical frequency having different aspect ratios and sampling rates (1,024 × 768 @ 60Hz,
1,280 × 768 @ 60Hz and 1,366 × 768 @ 60Hz).
Auto 1024×768
Auto: Automatically selected from 1024×768/1280×768/1366×768.
Switch the setting to suit the input signal for better display depends on the angle of view or display resolution
condition.
Note:
After making this setting, be sure to make each adjustment (such as "Auto Setup") on the "Pos. /Size" menu as
necessary. (see page 25)
access
2
select
1
SECAM M.NTSC
1280×768 1366×768
Select the item and set.
For Video (S VIDEO)
Signal
3D Y/C Filter (NTSC) On
Colour system Auto
For Component
[ Component ]
Signal
FRAME CREATION ON
XGA Mode Auto
H-Freq. 33.7 kHz
V-Freq. 60.0 Hz
Signal Format 1125(1080)/60i
NTSC
Setup menu
For RGB
[ AV ]
Signal
Sync
XGA Mode
H-Freq.
V-Freq.
Signal Format
For Digital
(Example: HDMI input)
Signal
24p SMOOTH FILM
3D 24p Film Display
HDMI Range
H-Freq.
V-Freq.
Dot Clock Freq.
Signal Format
change
2
select
1
[ RGB ]
Auto
1024 ×768
33.7 kHz
60.0 Hz
1125(1080)/60i
[ Digital ]
Off
60Hz
Auto
33.7 kHz
60.0 Hz
108.0 MHz
1125(1080)/60i
45