Panasonic TH-85VX200W Operating Instructions Manual page 30

Adjusting Pos. /Size
Auto Setup H-Pos/V-Pos, H-Size/V-Size, Dot Clock and Clock Phase are automatically adjusted when the
RGB or PC signal is received.
This setting is enabled under the following conditions:
• When "Component/RGB-in Select" or "YUV/RGB-in select" in the "Setup" menu (see page 41) is set
to "RGB", this setting is enabled.
• When the signal is not PC format, this setting is enabled only if "Over scan" (see page 27) is "Off"
or "1:1 Pixel Mode" (see page 27) is "On", and H-Size/V-Size is not automatically adjusted.
This setting will be invalid and will not work under the following conditions:
• Aspect is set to "Just"
• "Under scan" is set to "On"
Using Remote Control
Auto mode
When the "Auto Setup" is set to "Auto" in the Options menu (see page 53), automatic position
adjustment starts:
• When the display power is turned ON.
• When the input signal is switched.
Notes:
• If the dot clock frequency is 162 MHz or higher, Dot Clock and Clock Phase cannot be
made.
• When digital RGB signal input, Dot Clock and Clock Phase cannot be made.
• Auto Setup may not work when a cropped or dark image is input. In such case, switch to
a bright image with borders and other objects are clearly shown, and then try auto setup
again.
• Depending on the signal, out of alignment may occur after Auto Setup. Carry out ¿ ne tuning
for the position/size as required.
• If Auto Setup cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz,
1280×768@60Hz, and 1366×768@60Hz), pre-selecting the individual signal in "XGA Mode"
(see page 45) may results in correct Auto Setup.
• Auto Setup does not work well when a signal such as additional information is superimposed
out of valid image period or intervals between synchronizing and image signals are short, or
for image signal with tri-level synchronizing signal added.
• If Auto Setup cannot adjust correctly, select "Normalise" once and press OK button, then
adjust Pos. /Size manually.
H-Pos Adjust the horizontal position.
H-Size Adjust the horizontal size.
Dot Clock (During Component, RGB and PC input signal)
Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this
happens, adjust so that any such noise is minimized.
Clock Phase (During Component, RGB and PC input signal)
Eliminate the À ickering and distortion.
26
When on the remote control is pressed, "Auto Setup" will be executed.
When Auto Setup does not work, "Invalid" is displayed.
V-Pos Adjust the vertical position.
V-Size Adjust the vertical size.