Pc Input Terminals Connection - Panasonic TH-85VX200W Operating Instructions Manual

Connections

PC Input Terminals connection

COMPUTER
Notes:
• With regard to the typical PC input signals that are described in the applicable input signals list (see page 62), adjustment
values such as for the standard picture positions and sizes have already been stored in this unit. You can add up to eight
PC input signal types that are not included in the list.
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning
frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
• The display resolution is a maximum of 1,440 × 1,080 dots when the aspect mode is set to "4:3", and 1,920 × 1,080
dots when the aspect mode is set to "16:9". If the display resolution exceeds these maximums, it may not be possible
to show ¿ ne detail with suf¿ cient clarity.
• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will
need to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the speci¿ ed
frequency range.
• Component Input is possible with the pin 1, 2, 3 of the Mini D-sub 15P Connector.
• To use sync input VBS signals, use the connector which incorporates a 75-ohm termination resistance and which is
available on the market, for the connection of the HD connector where the VBS signals are to be input.
• Change the "Component/RGB-in select" setting in the "Setup" menu to "Component"
(when Component signal connection) or "RGB" (when RGB signal connection). (see page 41)
Signal Names for Mini D-sub 15P Connector
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
Pin Layout for PC Input
Terminal
12
Connect a cable which matches
the audio output terminal on the computer.
Conversion adapter
(if necessary)
Pin No. Signal Name
1 R (P /C )
R R
2 G (Y)
3 B (P /C )
B B
4 NC (not connected)
GND (Ground)
5
Audio
Stereo mini plug (M3)
RGB
PC cable
Pin No. Signal Name
6 GND (Ground)
7 GND (Ground)
8 GND (Ground)
9 +5 V DC
GND (Ground)
10
(Female)
Mini D-sub 15p
(Male)
Pin No. Signal Name
11 NC (not connected)
12 SDA
13 HD/SYNC
14 VD
SCL
15