Accessories; Accessories Supply; Remote Control Batteries - Panasonic TH-85VX200W Operating Instructions Manual

Accessories

Accessories Supply

Check that you have the accessories and items shown
Remote Control
Transmitter
N2QAYB000562
3D Eyewear set
(see page 20)
Operating Instructions
Ferrite core × 2
J0KG00000014

Remote Control Batteries

Requires two R6 batteries.
1. Pull and hold the hook, then open
the battery cover.
Hook
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, ¿ re or the like.
Fixing band × 2
Batteries for
the Remote TMME203
Control
Transmitter
(R6 (UM3) Size × 2)
These accessories will be used by professional installers when
Screwdriver
they install the unit.
TH-85VX200W
For 3D Eyewear
(see page 21)
TH-103VX200W
Noise cut ¿ lter
TXZDM011MBE
Use the Ferrite cores and Noise cut ¿ lter to comply
with the EMC standard. (see page 55)
2. Insert batteries - note correct
polarity ( + and -).
Open
"R6 (UM3)" size
Power supply cord
Eyebolt cap × 1
Eyebolt cap × 1
Close
TH-85VX200W
Use the clamper
when connecting a
LAN cable.
(see page 55)
Eyebolt × 1 Allen wrench
(M12)
Eyebolt × 1 Allen wrench
(M16)
Helpful Hint:
For frequent remote control
users, replace old batteries
with Alkaline batteries for
longer life.
Clamper × 1
TMM15412-2
7