Pc Input Terminals Connection - Panasonic TH-42PHW5 Operating Instructions Manual

Connections
PC Input Terminals connection
COMPUTER
\
\
\
\
\
\
\
\
\
Less than
Ferrite core (small size) ' 3" 15/16,
(supplied) _i (10 cm)
Audio
I Stereo plug
Connect a cable that matches
the audio output terminal on the computer.
Installing the ferrite core (Small size)
two :_ _O._en
Pull back the tabs
_ (in places)
the cable
/ _ through and close
Installing the ferrite core (Large size)
Open
IwPull back the tabs
(in two places)
Press the cable
through and close
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.6 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200
lines.)
(2) The display resolution is a maximum of 768 x 768 dots (TH-42PHW5) / 1,024 x 768 dots (TH-50PHW5) when the
aspect mode is set to "NORMAL", and 1,024 x 768 dots (TH-42PHW5) / 1,366 x 768 dots (TH-50PHW5) when the
aspect mode is set to "FULL". If the display resolution exceeds these maximums, it may not be possible to show fine
detail with sufficient clarity.
(3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you will
need to make setting changes to the computer at the time of connection.
(4) Some PC models cannot be connected to the set.
(5) There is no need to use an adapter for computers with DOSN compatible D-sub 15P terminal.
(6) The computer shown in the illustration is for example purposes only.
(7) Additional equipment and cables shown are not supplied with this set.
(8) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
15