Selecting Stitch Types; Opening The Looper Cover And The Swingout Work Support; Threading Diagram On Waste Box - Pfaff hobbylock 799 Instruction Manual

Opening and closing looper cover
and work support
Push looper cover 12 fully to the right,
hold it, and swing it down.
To close the looper cover, push it up
until it locks.
To open work support 15, push it in
the direction shown by the arrow. To
close the work support, push it lightly
until it locks.
Selecting stitch types
Stitch types 1 to 8 are illustrated on
the machine behind the looper cover.
The needle combinations (A, B and C)
and the thread tensions used are
colourcoded. A needle chart with the
corresponding set screws is printed
underneath.
Important!
While the looper cover or work sup
port is open, power supply to the
machine is interrupted.
Important!
A
While the looper cover or work sup
port is open, the power supply to the
machine is cut off.
Threading paths for different stitch
types on the rear side of the waste
box.
On the righthand side the stitch types
(1 to 8) with the corresponding threa
ding points A are indicated.
Each threading path has its own colour.
Move the slide so that threading point
A for the required stitch type (1 to 8) is
coloured orange.
Now thread all colourcoded threading
paths, see pages 8 to 1 2.
Indication B shows you whether the
overedge looper must be engaged or
disengaged (see pages 33, 34).
Please note Only the eight stitch
types on the rear side of the waste box
can be set using the slide.
Other sttch types are shown in the
stitch selection table (pages 44 to 51).
7