Threading The Right Looper; Changing A Spool With The Machine Threaded - Pfaff hobbylock 799 Instruction Manual

9
Threading the right looper
Thread the right looper in sequence 1
to B and pull about four inches of
thread through the looper eye. The
thread path is marked in green in the
threading diagram on the rear side of
the waste box.
Important:
In order to achieve perfect sewing
results, the thread must be pulled
between the tension discs during
threading.
Note:
Changing a spool with the machine
threaded
Cut the threads off close to the thread
spool. Place new thread spools on
spool holders 22. Tie the ends of the
old thread and new thread together.
Pull the needle threads out of the
needles. Now pull the threads
through until the knots are about six
inches past the last thread guide
before the needles. Cut the knots off
and thread up the respective needles.
The looper threads can be pulled
through beyond the looper eyes. Pull
about four inches of thread through
the looper eye.
I