Engaging And Disengaging The Converter - Pfaff hobbylock 799 Instruction Manual

Engaging and disengaging the con
verter
Hand wheel 11 must be set as shown
in the illustration.
Set 2 at the marking line on the hou
sing.
Before you work with converter 40 the
right looper thread must be cut and
unthreaded from the looper eye.
All seams with converter 40 are only
sewn with left looper 32 and one or
two needles (see page 27).
The left looper thread placed over right
looper 31 must be pulled over the
point of the right looper in the direction
of the arrow as shown in the illustra
tion.
Push the slide of converter 40 to the
left until the triangular symbols are
aligned with each other. As you do so
the point of the slide must engage in
the eye of the looper, see Fig. A.
Converter engaged
=
position A
Converter disengaged
=
position B
Disengaging the converter
26
Turn hand wheel 11 slowly until the
left looper thread drops from the point
of right looper 31.
In this position, disengage the conver
ter (position B).
For threading the right looper,
see page 9.