Roll-Out Rack; Oven Vent - KitchenAid KIRS608BSS0 User Instructions

The roll-out rack allows easy access to position and remove food in
the oven. The roll-out rack will fit in all positions except the top rack
position 7.
Open Position
A. Rack frame
B. Sliding rack
To Insert Roll-Out Rack
1. Angle the front of the rack assembly up and insert the rack
frame into the "V" cutout in the rack guides of the oven cavity.
/i I\
A B
NOTE: To fully extend the roll-out rack, pull the sliding rack
forward, and continue pulling until the rack frame slides forward.
7
A
S,//'
A. Sliding rack
B. Rack frame
Closed and Engaged Position
....................... A
A. Rack frame
B. Sliding rack
2=
3.
A. "V" cutout
B. Rack guides
Keep rack assembly lifted up at an angle and push in to bypass
the lower "V" cutout.
Lower the front of the rack assembly and gently slide rack
assembly into oven, bypassing the "V" cutouts. Push the rack
assembly to the back of the oven until it stops.
A
A. "V" cutout
B. Rack guides
To Remove Roll-out Rack
1. Push the sliding rack in completely so that it is in the closed
and engaged position.
2. Using 2 hands, gently pull the sliding rack and the rack frame at
the same time to the "V" cutout. Angle the rack so that the front
is higher than the back, and gently pull rack past "V" cutout
and then out of the oven.
To avoid damage to the sliding rack, do not place more than 25 Ibs
(11.4 kg) on the rack.
Do not clean the roll-out rack in a dishwasher. It may remove the
rack's lubricant and affect its ability to slide.
See the "General Cleaning" section for more information.
The oven vent releases hot air and moisture from the oven, and
should not be blocked or covered. Blocking or covering the oven
vent will cause poor air circulation, affecting cooking and cleaning
results. Do not set plastics, paper or other items that could melt or
burn near the oven vent.
13