Roll-Out Rack - KitchenAid KSGB900ESS2 User Manual

Baking Cookies and Layer Cakes on 2 Racks
Baking Layer Cakes
For best results when baking cakes on 2 racks, use the Convection
Bake function, a flat rack in rack position 2 and a Max Capacity Oven
rack in rack position 6. If you do not have a Max Capacity Oven
Rack, use a flat rack in rack position 5. Place the cakes on the racks
as shown. Keep at least 3" (7.6 cm) of space between the front of the
racks and the front cakes.
Baking Cookies
For best results when baking cookies on 2 racks, use the Convection
Bake function, a flat rack in rack position 2 and a Max Capacity Oven
rack in rack position 6 or a flat rack in position 5.

Roll-Out Rack

The roll-out rack allows easy access to position and remove food in
the oven. It is not recommended to use the roll-out rack in the top
rack, position 7, or the bottom rack, position 1.
Open Position
A. Rack frame
B. Sliding rack
Closed and Engaged Position
A. Rack frame
B. Sliding rack
To Insert Roll-Out Rack
1. Angle the front of the rack assembly up, and then insert the
2. Keep rack assembly lifted up at an angle, and then push in to
3. Lower the front of the rack assembly, and then gently slide
A
B
4. Reach through the rack to hold the sliding rack and the front
A
B
To Remove Roll-Out Rack
1. Push the sliding rack in completely so that it is in the closed
2. Reach through the rack to hold the sliding rack and the front
3. Using 2 hands, gently pull the sliding rack and the rack frame
14
rack frame into the "V" cutout in the rack guides of the oven
cavity.
A. "V" cutout
B. Rack guides
bypass the lower "V" cutout.
rack assembly into oven, bypassing the "V" cutouts. Push the
rack assembly into the oven until it stops at the ladder in the
back of the oven.
A
A. "V" cutout
B. Rack guides
C. Ladder hook
D. Ladder
crossbar. Lift the front of the rack assembly, and then push the
rack assembly to the back of the oven. Lower the front of the
rack assembly so the ladder hook engages with the ladder on
both sides of the oven.
A
A. Sliding rack
B. Front crossbar
and engaged position.
crossbar. Lift the front of the rack assembly to disengage the
ladder hook from the ladders at the rear of the oven, and then
pull the rack assembly forward.
at the same time to the "V" cutout. Angle the rack so that the
front is higher than the back, and then gently pull rack past "V"
cutout and then out of the oven.
A
B
B
C D
B