Replacing Oven Light - KitchenAid ARCHITECT SERIES II KGRS308X Use & Care Manual

Care & Cleaning
General cleaning
Refer to the Cleaning recommendation table in the
Care & Cleaning section for more detailed information
about cleaning specific parts of the range.
Before manually cleaning any part of the
range, be sure all controls are turned OFF and the range
is COOL. The range may be hot and can cause burns.
I_Jl_qi_ Ammonia must be rinsed before operating
the oven. Provide adequate ventilation.
Aluminum foil and utensils
NEVER cover any slots, holes or
passages in the oven bottom or cover an entire oven
rack with materials such as aluminum foil. Doing so
blocks air flow through the oven and may cause
CARBON MONOXIDE poisoning. Aluminum foil
linings may trap heat, causing a fire hazard.
• Aluminum foil - Use of aluminum foil on a hot cooktop
can damage the cooktop. Do not use thin aluminum
cooking utensils or allow aluminum foil to touch the
surface burners under ANY circumstances.
• Aluminum utensils - The melting point of aluminum is
much lower than that of other metals. Care must be
taken when aluminum pots or pans are used on the
cooktop. If aluminum pans are allowed to boil dry when
using the cooktop, the utensil may be damaged or
destroyed.
Replacing oven light
Be sure the range is unplugged and all
parts are COOL before replacing oven light Wear a
leather-faced glove for protection against possible broken
glass.
The oven light is located at the rear of the oven cavity
and is covered with a glass shield held by a wire holder.
The glass shield protects the light bulb and must be in
place whenever the oven is in use.
To replace the interior oven light bulb:
1. Turn electrical power off at the main source or unplug
the range.
2. Press wire holder to one side to release the glass
shield that covers the light bulb.
3. Replace light with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder
back into place.
5. Turn power on at the main source (or plug the
appliance in to an electrical outlet).
6. The clock will then need to be reset. To reset, see
Setting clock in this Use & Care Guide.
glass
wire
holder
3O