Adjusting Oven Temperature; Operating Oven Light; Restoring Default Settings - KitchenAid ARCHITECT SERIES II KGRS308X Use & Care Manual

Setting Oven Controls
Adjusting Oven Temperature
Your appliance has been factory calibrated and tested to
ensure an accurate baking temperature. For the first few
uses, follow your recipe times and temperature
recommendations carefully. If you think the oven is
cooking too hot or too cool for your recipe times, you may
adjust the control so the oven cooks hotter or cooler than
the oven temperature displayed.
The oven temperature may be increased as much as
+35°F (+19°C) or decreased -35°F (-19°C) from the
factory calibrated settings.
Example -- To increase (+) or decrease (-) the
oven temperature by 20°F:
1. Press and hold Bake keypad until the control provides
the 2nd audible tone (about 6 seconds).
2. Enter 2 0 using numeric keypad.
3. Press Self Clean keypad to toggle between plus (+) if
increasing temperature or minus (-) if decreasing the
temperature. These symbols will show in the display.
4. Press START to accept change.
Important notes:
• Oven temperature adjustments made will not change
the Broil or Self Clean function temperatures.
• If the temperature shows an adjustment of -20°F, and a
+20°F adjustment is needed, you can toggle between
the minus (-) or plus (+) in the display when pressing
Self Clean keypad (See step 3).
• DO NOT USE oven thermometers such as those found
in grocery stores to check the temperature settings
inside your oven. These oven thermometers may vary
as much as 20 to 40°F degrees from actual
temperatures.
• The oven temperature adjustment may be made if your
oven control has been set to display °C (Celsius)
temperatures. Maximum and minimum settings for
Celsius are plus (+) or minus (-) 19°C respectively.
Operating Oven Light
The interior oven light will automatically turn ON when the
oven door is opened.
Press Oven Light to turn the interior oven light ON and
OFF whenever the oven door is closed. Note that the light
will not operate during Self Clean.
The interior oven light is located at the upper left rear wall
of the oven interior and is covered with a glass shield
held by a wire holder. The glass shield protects the bulb
from high temperatures and should always be in place
whenever the oven is in use.
To replace the interior oven light, see Replacing oven
light in the Care & Cleaning section.
Restoring Default Settings
Important note:
Restoring your default settings will reset all recipes and
other adjustments to factory settings. These include 12 or
24 hour display, continuous bake or 12-Hour Energy
Savings mode, silent or audible control mode, Fahrenheit
or Celsius temperature display and any oven temperature
adjustment settings that have been made.
1. Press and hold the 7 keypad until the first single tone
sounds (6 seconds).
2. After the first tone press START once.
21