Jenn-Air JXP5032WW0 Use & Care Manual page 11

!_ _/_ E ¸ _ _:_I_,_,_ / _ _ _,_/_,9,_ _,
VU ...........I_:;,._.. @I ....... s.9 ,.,+_. O° ,,
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Remove the 5 screws from the top cover of the range hood to
uncover the terminal box.
3=
A
,J
4,
Run home power supply cable through strain relief into the
terminal box.
C
A. Home power supply cable
B. UL listed or CSA approved strain relief
C. Black wires
D. UL fisted wire connectors
E. White wires
F. Green (or bare) and yellow-green ground wires
A. Cover screws
A. Top cover
Remove terminal box cover and the knockout. Install a UL
listed or CSA approved 1/2"strain relief.
A. Knockout
B. Terminal box cover
5. Use UL listed wire connectors and connect black wires (C)
together.
6. Use UL listed wire connectors and connect white wires (E)
together.
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box.
Failure to do so can result in death or electrical shock.
7. Connect green (or bare) ground wire from home power supply
to yellow-green ground wire (E) in terminal box using UL listed
wire connectors.
8. Tighten strain relief screw.
9. Install terminal box cover.
10. Check that all light bulbs are secure in their sockets.
11. Reinstall top cover using 5 screws removed previously.
Tighten screws.
12. Reconnect power.
11