Jenn-Air JER8885QAF Use & Care Manual page 29

AINTENANCE
Warming Drawer
To remove warming drawer:
1. Empty drawer and pull out until it is fully open.
2. Locate the black triangle lever on each side of the drawer.
3. Press the lever down on the right side and lift the lever up on
the left side at the same time. Then pull drawer out another
inch.
4. Carefully pull the drawer all the way out holding on to the
sides, not the drawer front.
To replace warming drawer:
1. Pull the bearing glides to the front of the chassis glide. (See
picture below.)
2. Align the glide on each side of the drawer with the glide slots
on the range.
3. Push the drawer into the range until levers "click" (approxi-
mately 2"). Pull the drawer open again to seat bearing glides
into position. If you do not hear the levers "click" or the
bearing glides do not feel seated, remove the drawer and
repeat steps 1 through 3. This will minimize possible damage
to the bearing glides.
CHASSIS
BEARING
J
28