Fedders 23-23-0338N-002 Installation & Operation Manual page 9

6. DRAINING THE WATER
Draining the water
if the red light is lit, iodicatiog that the ioteroal
bucket is full, follow the recommended water draining
procedure:
D
Upper Drain Valve
1. The unit must be switched to the off position,
2, Place a container under the upper drain
valve and remove the rubber plug from the
upper drain valve (Fig. 7 a, b, c).
3, Insert the drain hose on the upper drain
valve pointing it towards the container,
4, Turn the upper drain valve from the closed
position to the open position (Fig. 7 b).
5, Turn the unit on, turn the thermostat to the
warmest setting and the switch to the dehu-
midify position. The unit will turn on, allow-
ing the pump to run and drain the water
from the unit (Fig. 6).
6, When the water stops draining from the unit,
turn off the unit,
7, Close the upper drain valve, remove the
drain hose, remove the container of water,
put the rubber plug back in the upper drain
valve (Fig. 7 d).
8, Tile unit can be turned to any operating
nlode.
important: When changing the operating mode back to
cooling do not forget to put the rubber plug back in
and turn the upper drain valve 900 to the right or to
the closed position. If this is not done the water will
come out of the unit when it is switched on,