Table of Contents
Advertisement
Available languages
Available languages
5. CONTROL
PANEL
Display
Control
The display
control
is used to change
the current
dis-
play setting.
There are three settings
on the display:
. TemperaturelFahrenheit
, Temperature/Celsius
. Timer
The display
will
return
from
the time
setting
to the
Fahrenheit
setting
after the control
has not been
depressed
for five seconds.
The temperature
on
the display
is the set temperature.
It is NOT
the
actual
room
temperature.
Time/Temperature
Controls
These buttons
are used to change the set temperature,
the clock, start time, and stop time.
Temperature
Change
Select
either
Fahrenheit
or Celsius
on the display
by using the Display
Control,
then change
the set
temperature
in increments
of 1° using the
Ti me/Tom peratu re.
Time
Change
Select
the time display
with
the Display
Control
and change
the clock
with
the Time/Temperature
controls.
The time
will
increase
or decrease
in one
minute
increments
with
each depression.
If either
the up or down
buttons
is held down,
the time
will
change
continuously
until the button
is
released.
The AM and PM lights will
change
appropriately
with
the clock.
Tinter
Controls
The Timer Controls
can be used to set a time for the
air conditioner
to start as well as a time
for the air
conditioner
to shut off.
Setting
a Start/Stop
Time
Depress
the start or stop button.
The display
will
now
show a time.
Use the Time/Temperature
controls
to set the desired
start/stop
time.
After
reaching
the desired
start/stop
time,
release
the
Time/Temperature
control
button.
The timer
will
be set after no buttons
have been depressed
for
five seconds.
A light above
the start and stop but-
tons will
indicate
when
the timer
is activated.
Shutting
the
Timer
Function
OFF
If the Start functinn is set:
Depress
tile Start button
for three
seconds.
The light will
go off and the start function
is
now deactivated.
If the Stop function
is set:
Depress
the Stop button
for three
seconds,
The light will
go off and the stop function
is
now deactivated.
Warning
Lights
These lights
will come
on when
the air conditioner
needs
attention.
Clean
Filter
Light
This light indicates
that the filter
needs to be
cleaned.
The air conditioner
will
continue
to run
even when
the light is on. However,
the filter
should
be cleaned
as soon as possible
after the
light comes
on. After cleaning
the filter,
press both
Time/Temperature
controls
simultaneously
to reset
the filter
monitor,
Drain
Water
Light
This light indicates
that the internal
water
bucket
needs to be drained.
The unit will
not operate
until
the water
has been drained.
See section
6
of the owners"
manual
for instructions
on how to
drain
the water. The air conditioner
must be set to
dehumidify
when
the water
is drained.
Advertisement
Table of Contents
