Lighting The Grill; Before Lighting; Match Lighting - Electrolux E57NB60ESS Use & Care Manual

Lighting the Grill
Back Knob Knob Knob Knob Knob Knob
Infrared #6 #5 #4 #3 #2 #l
Knob Knob
#SB2 #SB2
Left electronic igniter
l'or main burners
#2, #3.
#4, #5, #6 and back
inflared burner
BEFORE LIGHTING
Right electronic igniter tk_r
bottom infiared burner
(knob #l) & side burner
(knobs #SBI & #SB2)
Important! Before Lighting...
Check the gas supply line for cuts, wear or abrasion.
Always keep your face and body as far away from the
grill as possible when lighting.
GRILL BURNER LIGHTING
This unit comes equipped with (2) electronic starters and
(6) electrodes, The electronic igniter located on the
right shelf lights the side burner and the bottom
infrared burner. The electronic igniter on the left shelf
lights the main burners, which are controlled by knobs
2, 3, 4, 5, 6 and the back infrared burner.
LIGHTING THE GRILL WITH ELECTRONIC IGNITERS
Always open the lid before attempting lighting, Push and
turn one of the control knobs counter clockwise to the
"HIGH" position and immediately press the electronic
igniter button, You'll hear a snapping sound, It may be
necessary to hold the electronic igniter button for about
4 seconds, If the burner does not light in 4 seconds, turn
the knob to OFF and wait 5 minutes before trying again,
Repeat above steps to light remaining burners,
(See Fig, 16)
MATCH LIGHTING
If by chance the electronic igniter does not light the
burner, the burner may be lit with a match. Attach the
match to the match extender, located inside the right
cart door.
Keep your face as far away from the grill surface as pos-
sible and pass the match extender through the spaces
in the grill grates to the ports of the back crossover
burner between the flavor grids. Position the match
near the burner ports, then push and turn the control
knob counter clockwise to the "HIGH" position. (See Fig.
17-18)
NOTE: If the grill will not light after several attempts
see the trouble-shooting section of this manual. Turn
the control knobs to the OFF position when not in use.
Fig. 16
Fig. 17
Fig. 18
CONTROL KNOB LAYOUT:
The control knob bezel has
stamped markings for the HIGH
and LOW settings. Turning the
knob so the arrow faces the left
is the HIGH setting. Turning the
knob so the arrow faces down
is the LOW setting.