Download Print this page

Before Testing - Electrolux E57NB60ESS Use & Care Manual

57" stainless steel gas grill
Hide thumbs

Advertisement

Table of Contents
P
O
ration Leak Testi
GENERAL INFORMATION
Although all gas connections on the grill are leak tested prior to shipment, a complete gas tightness
check must be performed at the installation site due to possible shifting during shipment, installation or
excessive pressure unknowingly being applied to the unit. Periodically check the whole system for
leaks and immediately check the system if the smell of gas is detected.
BEFORE TESTING
Do not smoke while leak testing. Extinguish all open flames. Never leak test with an open flame.
Mix a solution of equal parts mild detergent or liquid soap and water.
TESTING
1. Turn off the burner control knobs.
2. Turn the top knob of the fuel supply cylinder counterclockwise
(right to left) two (2) rotations to open.
3. Apply the soap solution to connections of the fuel supply assembly. If no soap bubbles appear, there
is no gas leak. If bubbles form at the connections, a leak is detected. If a leak is detected, immediately
turn off the gas supply, tighten any leaking fittings, turn gas on, and repeat steps 1-3.
4. Turn off the knob on the fuel supply cylinder.
5. Turn on the burner control knobs for a moment to release the pressure in the hose, then turn the
control knobs back off.
6. Wash off soapy solution with cold water and towel dry.
Check all gas supply fittings before each use and each time the gas supply cylinder is connected to
the regulator. Have a qualified service technician leak test the grill any time a part of the gas system is
replaced.
Also it is recommended to perform a leak test at least once a year whether or not the LP. gas supply
cylinder has been disconnected.
NOTE: When leak testing this appliance, make sure to test and tighten all loose connections, including
the side burner. A slight leak in the system can result in a low flame, or hazardous condition. Most
L.P. gas tanks now come equipped with a leak detector mechanism internal to the tank, when gas
is allowed to escape rapidly it shuts off the gas supply. A leak may significantly reduce the gas
flow making the grill difficult to light or causing low flames.
NOTE: If you cannot stop a gas leak turn off the gas supply and call your local gas company or
the dealer you purchased
the appliance
from.
If necessary,
replace the faulty part with the
manufacturer's
recommended
replacement
part. A slight leak could cause a fire.

Advertisement

Table of Contents
loading

  Also See for Electrolux E57NB60ESS

  Related Manuals for Electrolux E57NB60ESS