Oven Racks; Oven Door - Kenmore 911.47704 Use & Care Manual

CAREANDCLEANING
Removable Parts
CLEANING MATERIALS
• Dishwashing detergent
" Warm water
• Scouring pad or soap-filled pad
Bump tn I__
Raok Guide
Raised Back t-__
of the R_,
TO REMOVE
1, Pull the racks out to the stop lock
position
2. Pull up the front of the rack and
slide under the bump of the rack
guide
TO CLEAN
Clean with warm water and detergent
For hard to remove stains, gently scrub
with a scouring pad or a soap-filled
pad Rinse well
Gray porcelain-coated oven racks may
also be cleaned in the oven during the
self-clean cycle it is necessary to wipe
the edges of gray porcelain-coated
oven racks with a light coating of
vegetable oil alter cleaning This will
help maintain the ease of sliding the
racks in and out of the oven
TO REPLACE
1. Place the raised back of the rack
onto the rack guides
2. Lift the front of the rack until the
raised back slides under the bump
of the rack guides
3. Slide the rack all the way back
The door is very heavy, Be careful
when removing and lifting the door,
Do not lift the door by the handle.
TO REMOVE
1,
2.
Fully open the door
Pull the hinge locks _1 !_
down towardthe door .1/_ Sl°t
frame, to the unlockedt'_/_" _
position This may /_:\t_,_."_
require a flat-blade tt\ _'f_
screwdriver tll/_
HingeLock
Pull binge locks
down to unlock
3o Firmly grasp both
sides of the door
at the lop
4,, Close door to the
door removal
position, which is
hailway between
the broil stop and
fully closed
5, Lift door up
and out until the
TO
Removal Position
hinge arm is clear of
the slot
REPLACE
2,
Firmly grasp both
sides of the door
at the top
With the door at
lhe same angle
as the removal
position, seal the
indentalion of lhe
hinge arm into Indentation
the bottom edge of
the hinge slot, The
notch in the hinge arm
must be fully seated
into the bottom of the
stot
Hinge
Arm
Bottom
Edge of
Slot
23