Kenmore 30" Built In Wall Oven Installation Instructions Manual
30" built in wall oven
Hide thumbs
Also See for 30" Built In Wall Oven:
- Use & care manual (44 pages) ,
- Installation instructions manual (13 pages) ,
- Use & care manual (32 pages)
Table of Contents
Advertisement
Installation
Instructions
30" Built In Wall Oven
911.41084,41085,41086,41089,41184,41185,41189,41785,
41789,41885,41889,47082,47084,47089,47822,47824,
47829,49002,49003,49004,49009,49012,49013,49014,
49019,49022,49023,49024,49029,49032,49033,49034,
49039
Questions? Contact
our Website
at: www.sears.com
Before you begin
Read these instructions
carefully and completely
• IMPORTANT-Save
these instructions
for
local inspector's
use.
• IMPORTANT-Observe
all governing
codes and ordiances.
ATTENTION:
INSTALLER
• Note to Installer-
Be sure to leave these
instructions
with the consumer.
• OWNER-
Keep these instructions
for future
reference.
• NOTE- This appliance
must be properly
grounded.
All electric wall ovens must be hard wired (direct wired) into an approved
junction box.
A "plug and receptacle"
is not permitted on these products.
Parts Included
4 screws (single)
8 screws (double)
Bottom Trim
Tools You Will Need
1/8" Drill Bit &
Phillips
Electric or
Screwdriver
Hand Drill
Materials Needed
Junction
Box
Wire Nuts
Strain Relief
Clamp
36" of String
Pub.
No. 31-10437
229c4053P419-1
1
Advertisement
Table of Contents
Related Manuals for Kenmore 30" Built In Wall Oven
Summary of Contents for Kenmore 30" Built In Wall Oven
- Page 1 Installation 30" Built In Wall Oven 911.41084,41085,41086,41089,41184,41185,41189,41785, Instructions 41789,41885,41889,47082,47084,47089,47822,47824, 47829,49002,49003,49004,49009,49012,49013,49014, 49019,49022,49023,49024,49029,49032,49033,49034, 49039 Questions? Contact our Website at: www.sears.com Before you begin • Note to Installer- Be sure to leave these instructions with the consumer. Read these instructions carefully and completely •...
- Page 2 Installation Instructions IMPORTANT SAFETY INSTRUCTIONS Electrical For Your Safety Requirements • Be sure your oven is installed properly by a qualified installer or service technician. This appliance must be supplied with the • Be sure the oven is securely installed in a proper voltage and frequency,...
- Page 3 Installation Instructions Pre- Installation Checklist Open the door to the stop position. ALL INSTALLATION INFORMATION ON THE FOLLOWING PAGES ARE TO BE USED FOR SINGLE AND DOUBLE OVEN INSTALLATION! Remove packaging materials. Check behind hinges, and under false bottom. Remove labels on door, plastic on trims and panel, and all tape around oven.
- Page 4 Installation Instructions Pre- Installation Checklist cont. Place the oven on a table or paper Cover hinge with towel roils platform even with the cutout or toweling. opening. (Platform must support 150 Ibs. single, 275 Ibs double.) Remove bottom trim from the top of the oven.
-
Page 5: Cutouts For Single Built-In-Oven
Installation Instructions Cutouts for Single Built-In-Oven CUTOUT WIDTH Cabinet Width 30" _--281/2" MIN. Recommended Cutout Location JUNCTION from Floor 32 1/2" ALLOW 11/16"FOR OVERLAPOFTHE Cutout Depth 23 1/2" Min. EDGESOFCUTOUT THE OPENING 22"TO CUTOUT WALLS MUST BOTTOM OF HEIGHT Cutout Width 28 1/2"... - Page 6 Installation Instructions Cutouts for Double Built-In-Oven CUTOUT WIDTH 28 1/2" MIN. 28 5/ Cabinet Width 30" JUNCTION Recommended LOCATION Cutout Location from Floor 12" ALLOW 11116" FOR OVERLAP OFTHE OVEN-_ 23 1/2" Min. Cutout Depth OVER SIDE EDGES OFCUTOUT Cutout Wdth 28 1/2"...
- Page 7 Installation Instructions Cutouts For Single Oven Under Counter Gas or electric cooktops may be installed over this oven, See cooktop installation instructions for cutout size, Gas and electrical connections See label on top of oven for for 30" gas cooktop must be approved cooktop models, located in an adjacent...
- Page 8 Installation Instructions Electrical Connections Turn off the circuit breaker or remove NEW CONSTRUCTION AND FOUR- fuses to the oven branch circuit. CONDUCTOR BRANCH CIRCUIT CONNECTION With the oven in front of the cabinet opening, on a table or platform, connect the flexible conduit to the electrical •...
- Page 9 Installation Instructions Electrical Connections cont. Do not shorten the flexible conduit.The conduit strain Relief Clamp must be CIRCUIT CONNECTION I THREE-CONDUCTOR BRANCH securely attached to the junction and the flexible conduit must be securely attached to the clamp. If the flexible conduit will not fit within the When connecting...
-
Page 10: Securing
Installation Instructions Securing the Oven With the conduit connected, the oven Drill four-I/8" pilot holes through the is ready to be slid into the cutout mounting holes (top and bottom) of the opening. side trim, for the four #8 screws provided. - Page 11 Installation Instructions Installing the Bottom Trim Key hole slot and wide flange at top D----_ Make sure the flat side is up on the bottom trim. _-2-] Find the Key Slot on the back of the trim. _3-_ Match the key slot with the rivet on the bottom of the side trim Lower trim mounting rivet on bottom of side...
- Page 12 Installation Instructions Replacing the Oven Door Make sure the hinge is in the door stop position. Remove the toweling or paper towel holder from the hinge. _--_ Grasp the door on both sides. _4-_ Hold the door over the hinges lining up the hinges with the hinge slots on the bottom of the door.
- Page 13 Installation Instructions Pre-Test Check List Check that the bottom trim is installed Remove all protective film if properly (see page 11). present, and any stickers. Check to be sure that all wiring is Check to be sure the mounting screws are installed and flush with the secure and not pinched or in contact with moving parts.
- Page 14 NOTES...
- Page 15 NOTES...
- Page 16 NOTES Pub. No. 31-10437 229c4053P419-1...