Table of Contents
Advertisement
I WARNING
• ALL RANGES
CAN TiP
• INJURY
TO PERSONS
•COULD
RESULT
• iNSTALL
ANTI-TIP
DEVICE
PACKED
WITH
RANGE
• SEE INSTALLATION
INSTRUCTIONS
STABILITY
DEVICE
INSTALLATION
INSTRUCTIONS
FOR
BRACKET
KIT
NO. 342473
TOOLS NEEDED:
Phillips head screwdriver
1 3/8" open end or adjustable wrench
Bracket sttachee to floor or wallto hold either rig ht or left
rear leg leveler. If fastening to floor, be surethat screws
do not penetrate elsctrlcal wiring or plumbing.
If this
cannot be determined, use shorter screws that will not
penetrate through flooring.
If the bracket came with your range, It Is shlppad at-
tached to the lower range back. Remove and discard
the shipping
screw that holds the bracket and then
follow Instructions below.
.
1. Decide whether the bracket will be Installed on the
right or left Side of range location.
2. If the bracket side of the range Is adjacent to a
cabinet, place the bracket against
beck wall and
cabinet as shown In Figure 1.
If there Is no adjacent cabinet, determlne where the
location of the range side (painted outside panel) will
be. Place the bracket with Its outside edge at this
location and against back wall. See Figure 1.
Dsterm Ine whether you wll! anchor the bracket to the
floor or wall. Fasten the bracket securely wIth the
screws provided.
Screws are self-drilling In wood,
plywood, particle and chip board, and most metal
framing.
Ifattachlng tomasonry, youcanbuysultable
screws
and anchors
at hardware
stores.
Use a
masonry drill to drill the requlrad holes.
4. Using the wrench, back out the four leg levelers at
least twotums.
Sse your Inatallatlon guide for more
leveling Information before positioning range.
5. Slide the range Into place. Be sure rear leg leveler
fully engages slot In bracket.
If range cannot be
moved beck far enough for rear leg leveler to enter
bracket, move bracket forward as required and attach
to floor In new Iocstlon.
ADJACENT
CABINET
OR FINAL
LOCATION
OF RANGE SIDE
PANEL
OUTSIDE EDGE OF
BRACKET TO BE
FLUSH WITH LEFT OR
RIGHT SIDE OF RANGE
\
WALL BEHIND
RANG
BRACKET
\
SCREW MUST ENTER "_,
WOOD OR METAL
|
WALL
PLATE
A'I'rACHMENT TO WALL
Fig. 1
Fig. 2
1
NCINS01-2
Advertisement
Table of Contents
