The Oven Light - Kenmore 665.95812 Use & Care Manual

REMOVING THE OVEN DOOR (contd.)
2, Hold oven door so that the top edge of each
hinge hanger is horizontal. Insert hinge hangers
into the front frame hinge slots.
3, Tilt top of door toward range. Slide hinge
hangers down onto front frame support pins.
NOTE: Make sure the hinge hangers are fully
seated and engaged on the support pins.
4, Insert the door stop clip with the angular surface
at the top of the frame hinge slot, then push in
the bottom of the clip until flanges are flush with
the front frame.
5, Open the door completely and remove the door
removal pins. Save door removal pins for future
use.
6, Close the door.
7, Check for alignment to make sure door is
installed evenly.
Door stop Range
clip
Door removal
pin hole
O
Door removal
pin hole
Hinge
hanger
Front frame
hinge slot
Angular
surface of
door stop
clip
THE OVEN LIGHT
The oven light will come on when you open the
oven door. The oven light will not work during the
Self-Cleaning cycle.
et@@_' S O/ese .... , O
• Press the OVEN pad.
L..._M
1, Unplug range or disconnect power.
2, Remove the glass bulb cover in the back of the
oven by turning it
counterclockwise.
4.
Replace the light bulb cover by turning it clockwise.
3, Remove the light bulb from its socket by turning
counterclockwise. Replace the bulb with a 40-
watt appliance bulb.
5. Plug in range or reconnect power.
38