Table of Contents
Advertisement
IMPORTANT SAFETY
INSTRUCTIONS
SAVE
THESE
INSTRUCTIONS
Read
all instructions
before
using
this
appliance.
When
using
gas
or electrical
appliances,
basic
safety
precautions
should
be followed,
including
the following:
Injury
To Persons
Could Result
Device Packed
With
See Installation
!
Tools
you
will
need:
• Phillips head screwdriver
• 1 3/8" open end or adjustable wrench
1. Remove the bracket from the
prepack located inside the oven.
2. Decide whether the bracket will be
installed on the right or left side of
range Location.
3,
If the bracket side of the range is
adjacent to a cabinet,
place the
bracket against back wall and
cabinet as shown in Fig. 1.
If there is no adjacent cabinet,
determine
where the location of
the range side (painted
outside
panel) will be. Place the bracket
with its outside edge at this
location and against back wall.
See Fig. 2.
4. Determine whether you will anchor
the bracket to the floor or wall.
Make sure this location is clear of
electrical
wiring or plumbing.
Outside
Edge Of
Bracket To Be
Flush With Left Or
ide Of Range
Fig.
I
So
Fasten
the bracket
securely
with
the screws
provided.
Screws
are
self-drilling
in wood,
plywood,
particle
and chip
board,
and most
metal
framing.
If attaching
to
masonry,
you can buy suitable
screws
and anchors
at hardware
stores.
Use a masonry
drill to drill
the required
holes.
Bracket II Wall
Screw Must Enter
\
II
Plate
Wood Or Metal -,_,._
I
I_1
Fig. 2
Attachment To Wall
o
1
Using the wrench,
back out the
four leg levelers at least two turns.
See your installation
guide for
more leveling information
before
positioning
range.
Slide the range into place. Be sure
rear leg leveler fully engages
the
slot in the bracket.
If range cannot
be moved back far enough for
rear leg leveler to enter bracket,
move bracket forward
as required
and attach to floor in new location.
3
Advertisement
Table of Contents
