How To Set A Clean Cycle; To Stop A Clean Cycle; After The Cycle - Kenmore 911.94378690 Owner's Manual

t. For best results,
follow the steps
in PREPARNNG
YOUR OVEN,
2. If your handle is
hidden, lift the
cooktop and puff
the handle out as
far as it will go.
3. Slide the handle to the right. Do not force
the handle_ If it does not slide easily, you
have not pulled it out from the latch co ver
as far as it will go. Repeat Step 2
4. Turn the oven control knob to "CLEAN".
The "LOCK DOOR" and "OVEN ON"
indicator lights will glow,
If you turn the oven control knob to CLEAN
and forget to lock the door, the "LOCK
DOOR" indicator light will flash, alerting,you
to lock the door.
5. The clean cycle lasts 4 hours and 20
minutes. The "OVEN ON" and "LOCK
DOOF_" indicator lights will blink at the
end of the clean cycle. The oven door
cannot be unlocked until the temperature
has cooled and the door handle slides
easily to the left.
6. After the cycle is finished, turn the oven
control knob to the off position and unlock
the door
CYCLE
Turn the oven control knob to the off position.
You will need to wait for the oven temperature
to drop below the lock temperature (approxo 1
hour) before attempting to open the door The
indicator light will not blink if the cycle is
interrupted
After the cycle, you may .....,--_-J
notice some white ash in
the oven ,Just wipe it up
with a damp cloth or
sponge
If white spots remain, scrub them with a soap-
filled steel wool pad_ Be sure to rinse
thoroughly_ These are usually deposits of salt
that cannot be removed during the cycle.
If for any reason you are not satisfied
with the cleaning results, just repeat
the cycle.
15