Self-Cleaning; To Set The Self-Clean Cycle - Kenmore Dual Fuel Range Use & Care Manual

Elite dual fuel range
Hide thumbs Also See for Dual Fuel Range:
Table of Contents

Advertisement

Available languages

Available languages

Self-Cleaning

During the self-cleaning cycle,
the outside of the wall oven can become very
hot to the touch. DO NOT leave small
children unattended near the appliance.
The health of some birds is
extremely sensitive to the fumes given off
during the self-clean cycle of any wall oven.
Move birds to another well ventilated room.
DO NOT line the oven walls,
racks, bottom or any other part of the
appliance with aluminum foil. Doing so will
destroy heat distribution, produce poor baking
results and cause permanent damage to the
interior (aluminum foil will melt to the interior
surface of the oven).
DO NOT force the oven door
open. This can damage the automatic door
locking system. Use caution when opening
the door after the Self-Cleaning cycle is
completed. The oven may still be VERY
HOT.
DO Hand
Clean Door
DO NOT Hand Clean
Oven Door Gasket
Note: See additional cleaning information for
the oven door in the General Care &
Cleaning section.

To Set the Self-Clean Cycle

Refer to the Oven Control Guide for Self-Clean Cycle settings.
Self-Cleaning Oven
A Self-Cleaning oven cleans itself with high temperatures (well above
cooking temperatures) which eliminate soils completely or reduces them
to a fine powdered ash you can wipe away with a damp cloth.
Adhere to the following cleaning precautions:
Allow the oven to cool before cleaning.
Wear rubber gloves when cleaning any exterior parts of the oven
manually.
DO NOT clean the oven door gasket. The woven material of the
oven door gasket is essential for a good seal. Care should be taken
not to rub, damage or remove the gasket.
DO NOT use any cleaning materials on the oven door gasket. Doing
so could cause damage.
Remove the ladder racks, oven racks and meat probe during
self-cleaning. These items will be permanently damaged by the
high cleaning temperatures. If the racks are not removed, the self-
clean cycle will cause them to discolor and make them difficult to
slide. If this occurs, coat the racks with cooking oil to make them
easier to slide again.
Remove any excessive spillovers in the oven cavity before
starting the Self-Cleaning cycle. To clean, use hot, soapy water and
a cloth. Large spillovers can cause heavy smoke or fire when
subjected to high temperatures. DO NOT allow food spills with a
high sugar or acid content (such as milk, tomatoes, sauerkraut, fruit
juices or pie filling) to remain on the surface as they may leave a
dull spot even after cleaning.
DO Hand
Clean any soil from the oven frame, the door liner outside the oven
Clean Frame
door gasket and the small area at the front center of the oven
bottom. These areas do not heat sufficiently to burn soil on. Clean
with soap and water.
NOTE: Prior to setting the Self-Clean cycle, any spills remaining on the
oven bottom should be removed.
has been turned OFF. The element may still be hot and burns may
occur if this element is touched before it has cooled sufficiently.
What to Expect during Cleaning
While the oven is in operation, the oven heats to temperatures much
higher than those used in normal cooking. Sounds of metal expansion
and contraction are normal. Odor is also normal as the food soil is being
removed. Smoke may appear through the oven vent.
If heavy spillovers are not wiped up before cleaning, they may flame and
cause more smoke and odor than usual. This is normal and safe and
should not cause alarm. If available, use an exhaust fan during the self-
cleaning cycle.
The oven broil element may appear to have cooled after it
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Range

Table of Contents