Kenmore 91195876891 Installation Instructions Manual

INSTALLATION INSTRUCTIONS FOR YOUR NEW
FREE-STANDING
ELECTRIC RANGE
Before you begin. Read these instructions completely and carefully.
IMPORTANT - Save these instructions for local inspector's use.
IMPORTANT- OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer. Be sure to leave these instructions with the Consumer.
Note to Consumer. Keep these instructions with your Use and Care Book for future
reference.
r
ii
_ AUTION:
For Personal Safety remove house
fuse or open circuit breaker before
beginning installation. Failure to
do so couldresult in serious injury
or even death.
All rough-in and spacing dimensions must be met
for safe use of your range. Electricity to the range
can be disconnected at the outlet without moving
the range ff the outlet is in the preferred location
(remove lower drawer).
To reduce the risk of bums or fire when reaching
over hot surface elements, cabinet storage space
above the cooktop should be avoided, ff cabinet
storage space is to be provided above the cooktop,
the risk can be reduced by installing a range hood
that sticks out at least 5" beyond the front of the
cabinets. Cabinets installed above a cooktop may
be no deeper than 13".
Be sure your appliance is properly installed and
grounded by a quafified technician.
I_ ARNING:
To reduce the risk of tipping the
appliance, the appliance must be
secured by properly installed
anti-tip device packed with the
appliance.
ii i]
31-10249
229C4053P003-3
TOOLS NEEDED: Phillips head screwdriver and
1 3/8" open end or adjustable wrench
Bracket attaches to floor or wall to hold either right
or left rear leg leveler. If fastening to floor, be sure
that screws do not penetrate electrical wiring or
plumbing. If this cannot be determined, use shorter
screws that will not penetrate through flooring.
If the bracket came with your range, it is shipped
inside the prepack found in the oven. Remove and
discard the shipping screw that holds the bracket
and then follow instructions below.
11.Decide whether the bracket will be installed on
the right or left side of range location.
2. If the bracket side of the range is adjacent to a
cabinet, place the bracket against back wall
and cabinet as shown in Figure 1.
1