Kenmore 362.7262 Use & Care Manual page 45

Theshutter forthebottom (oven) b urner is nearthe back
wallbehind thestorage drawerRemove thedrawer. S ee
theCareandCleaning section in thisguide°
To
adjust the flow of air to either burner, loosen the
Philtips head screw and rotate the shutter toward open
or closed position as needed.
The flames for the top (broil) burner should burn steady
with approximately 1" blue cones and should not extend
out over the edges of the burner baffle.
To determine if the bottom burner flames are burning
properly, remove the oven bottom. Flames should have
approximately I" blue cones and, if range is supplied with
natural gas, should burn with no yellow tipping. (With
most LP gas, small yellow tips at the end of outer cones
are normal.) Flames should not lift off burner ports If
lifting is observed, gradually reduce air shutter opening
until flames are stabilized
To remove the oven bottom:
1. Remove the knurled screws holding down rear of the
oven bottom°
2. Grasp the oven bottom at finger slots on each side.
3. Lift the rear of the oven bottom enough to clear
the lip of the range frame, push it back, and then pull
it up and out
STEP 8
Leveling the Range
1. Install the oven shelves
in the oven, then position
the range where it will be
installed.
.
Check for levelness by
placing a spirit level or a
partially filled cup of water
on one of the oven shelves°
tf using a spirit level, take
two readings--with the
level placed diagonally first
in one direction and then
the other
(on some models)
Raise
range
Lower
range
3. Remove the storage drawer The front leveling Iegs
can be adjusted from the bottom and the rear legs
can be adjusted from the top or bottom
4. Use an open-end or __" AL°w_r
adjustable wrench to
adjust the leveling legs
until the range is level.
5, After the range is level, LeegelS"'-'=_ r,.__ _1 _-
slide the range away
from the wall so that the
Anti-Tip device can be
installed. (on somemodeFs)
45