Remove dusting brush or upholstery tool, Snap into
Remove crevice tool from the wand by twisting.
Remove the extension wand from the hose. Twist the
wand to the left and pull from the hose end,
Unlock the wand by
turning the wand
locking ring to the
Slide the lower wand into
the upper wand, Turn the wand
locking ring to the LOCK position.
Place the crevice tool down into the compressed
Snap into the appropriate
Be sure the unit is turned off, Reinsert the hose fully
into the opening on the lower body from which it
Press firmly to assure connection.
NOTE: Brush assembly will not turn if hose is not fully
DO NOT place hands or feet underneath the unit
when inserting the hose. The brush assembly begins
to revolve rapidly when the vacuum is turned on
and isswitched to a carpet height setting.
I DO NOT pull the vacuum cleaner around the room |
by the lhose. Property damage could result.
NOT INCLUDED IN ALL MODELS
The stretch hose attached
to the vacuum
has two "J" shaped slots in the end where
The extension hose has two tabs on the end that can
be pushed into the slots and twisted to attach
two hoses together.
and the telescoping
wand can be
to the other end of the extension hose for
If your model did not come with an extension hose.
one can be purchased
at any SEARSretail store
under part number 20-52571.
hose attached, the cleaner should be on a solid
surface on the same level or below the level of
the user's feet. DO NOT use the hoses when the
cleaner is above the level of the user'sfeet.
ATTACHMENT U SECHART
*Always clean attachments before usingon fabrics.