Kenmore 1163511290 Owner's Manual page 17

Remove any dirt or debris in the belt path area or in
the brush roller area,
Exploded View - Brush Assembly
End Cap
Carefully
remove the
brush end
caps and
metal washers
to check for
string and hair
build-up.
Remove any
string or debris,
IMPORTANT
Replace the
washers and
/
then the end
caps,
See exploded
view for correct
assembly,
TO REPLACE BELT:
Loop the end of the new belt on the brush assembly,
(NOTE: See page 2 for Belt #,)
New Belt
Belt
Groove
Loop the new belt on the motor drive shaft.
Align the I .\'_rf_..
square
I
extension on
each end cap
with the slots in
the frame of
the base,
NOTE: Care
must be taken
due to the belt
tension during
reassembly.
|
Press firmly, checking to see that each end is
completely inserted,
Check to see that the belt is centered in the belt
groove, Turn the brush assembly with your fingers to
see that it turns freely,
15