To Store Attachments:
Remove dusting brush or upholstery tool. Snap into
Remove crevice tool from the wand by twisting.
Unlock the wand by turning the wand locking ring to the
the lower wand into the
upper wand. Turn the
wand locking ring to
the LOCK position.
Place the crevice tool down
into the compressed wand.
Snap into the appropriate storage location.
Be sure the unit isturned off. Reinsert the hose fully into
the opening on the lower body from which it was
Pressfirmly to assure connection.
NOTE:Brushassembly will not turn if hose is not fully
Personal Injury Hazard
DO NOT place hands or feet underneath the unit
when inserting the hose. The brush assembly begins
to revolve rapidly when the vacuum is turned on and
is switched to a carpet height setting.
NOT INCLUDED IN ALL MODELS
The stretch hose attached
to the vacuum cleanler
has two "J" shaped slots in the end where attach-
ments fit into.
The extension hose has two tabs on the end that can
be pushed into the slots and twisted to attach
two hoses together.
and the telescoping
wand can be
to the other end of the extension hose for
!f your mode
did not come with an extension
one can be purchased
at any SEARSretail store
under part number 20-52571.
When using the regular hose or with the extension
hose attached, the cleaner should be on a solid
surface on the same level or below the level of the
user's feet. DO NOT use the hoses when the cleaner is
above the level of the user's feet.
ATTACHMENT U SECHART
*Always clean attachments
before using on fabrics.