Troubleshooting Guide - Kenmore 91589 Use & Care Manual

How do
1.
2.
3.
4.
5.
6.
7.
8.
I replace an empty CO2tank?
Close tank drum valve by turning clockwise.
Unscrew adjustment Set Screw (counter-clockwise) as far as it will go and close shut off valve.
Remove regulator from empty tank.
Remove dust cap from the new full tank. Open and close drum valve quickly to blow of the dust from the outlet.
With drum valve in closed position, reattach regulator to the tank. Be sure to check the washer, which is pre-installed on the
CO2 regulator.
Open drum valve all the way. (This is important because this drum valve seals in two places.)
Readjust regulator pressure by turning set screw and open shut off valve.
Tank Information: Tank must always be fastened in the upright position.
It takes about 1/2 lb. of CO2to dispense 1/2 barrel keg of beer.
A 5 lb. CO2tank should dispense between 8-10 ½ barrel kegs or 18-20 1¼barrel kegs.
Full weight of 5 lb. tank is appx. 17 ½ Ibs.
When dispensing beer into the glass, if you find that the beer is Cloudy, Flat, Bubbly, Off-Taste, Sour, Wild or Tail-End Beer, refer to
some of the following hints.
Condition
C_o_dy Bee_
The beer in the glass
appears hazy, and not clear.
Cause Correction
Excessively low temperatures may
cause hazy or cloudy beer,
particularly when the beer lies in
the cold coil for long periods of
time.
The beer faucet was only opened
partially.
Make certain that the lines are thoroughly cleaned and
then raise the temperature slightly.
Open the faucet quickly and completely.
• Replace any worn washers and parts in the faucet
when necessary to allow the faucet to be fully opened.
IIIoose Foam
Large soap-like bubbles
that settle quickly.
This is generally the same as
the Flat Beer condition. See the
Flat Beer
causes above.