Troubleshooting - Kenmore 66572164302 Use & Care Manual

The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1. Pull drawer straight out to the first stop.
2. Lift up the back of the drawer and pull out.
To Replace:
1. Fit the ends of the drawer rails into the guides in the cavity.
2. Slide the drawer closed.
Remove all items from inside the warming drawer, and allow the
unit to cool completely before attempting to remove the drawer.
To Remove:
1. Open drawer to its full open position.
2. Locate the black triangle-shaped tabs on both sides of the
drawer.
1. Tab
3. Press the tab down on the right side, and lift tab up on the left
side at the same time, then pull drawer out another inch.
4. Holding the drawer by its sides, not its front, carefully pull it
all the way out.
To Replace:
1. Align the drawer glides with the receiving guides.
2. Push drawer in all the way.
3. Gently open and close the drawer to ensure it is seated
properly on the slides.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of
an unnecessary service call.
Nothing will operate
• Is the power outlet properly wired and polarized? Try
another outlet to check for proper wiring and polarity.
• Is the power supply cord unplugged? Plug into a properly
grounded 3 prong outlet.
Has a household fuse blown or has the circuit breaker
been tripped? Replace the fuse or reset the circuit.
is the main or regulator gas shutoff valve in the off
position? See Installation Instructions.
Is the range properly connected to the gas supply?
Contact a Sears trained repair specialist or see Installation
Instructions.
Surface burners will not operate
• Is this the first time the surface burners have been used?
Turn on any one of the surface burner knobs to release air
from the gas lines.
•
On some models, is the Cooktop Lockout set? See
"Cooktop Lockout" section.
• Is the control knob set correctly? Push in knob before
turning to a setting.
• Are the burner ports clogged? See "Sealed Surface
Burners" section.
Surface burner flames are uneven, yellow and/or noisy
• Are the burner ports clogged? See "Sealed Surface
Burners" section.
Are the burner caps positioned properly? See "Sealed
Surface Burners" section.
Is the burner damaged? On models with caps, look for a
warped cap. If cap will spin freely on a flat surface, painted
side down, the cap is warped. Switch cap with a different
surface burner to check for further warping. Contact a Sears
trained repair specialist. See back cover.
Is propane gas being used? The appliance may have been
converted improperly. Contact a Sears trained repair
specialist. See back cover.
Surface burner makes popping noises
• Is the burner wet? Let it dry.
Excessive heat around cookware on cooktop
Is the cookware the proper size? Use cookware about the
same size as the surface cooking area, element or surface
burner. Cookware should not extend more than 1 in. (2.5 cm)
outside the cooking area.
Oven will not operate
• Is the power outlet properly wired and polarized? Try
another outlet to check for proper wiring and polarity.
• Is this the first time the oven has been used? Turn any one
of the surface burner knobs on to release air from the gas
lines.
• Is the electronic oven control set correctly? See
"Electronic Oven Control" section.
• On some models, is the Oven Lockout set? See "Oven
Lockout" section.
Triple Task Oven Drawer will not operate
• Is the self clean cycle on? The oven drawer will not operate
when the self clean cycle is on.
24