Kenmore 66572164302 Use & Care Manual page 23

To Install Starter and/or Bulb:
1. Fit starter prongs into starter mounting base and turn
clockwise.
To Remove:
1. Open the oven door. Insert door removal pins, included with
your range, into both hinge hangers. Do not remove the pins
while the door is removed from the range.
2. Slide bulb prongs into bulb mounting base ends. Roll the bulb
forward or backward 90 ° until it clicks.
3. Push down on the left end of the bulb mounting base. When
the assembly latches, it will click.
Replace lens cover. Position the two rear lens cover tabs in
front of the two metal spring clips (located directly behind the
bulb). Push back and down on the lens cover to lock into
position.
5. Plug in range or reconnect power.
Oven
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
Before Removing:
1. Use a putty knife or screwdriver and insert it at the bottom
corner of the door stop clip.
1. Removal Pins
2. Hinge Hanger
2. Carefully close the door until it rests against the door removal
pins.
3. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
4. Pull door straight up, then toward you. Hinge hangers will
slide out of front frame hinge slot. Do not remove door
removal pins until the door is replaced on the range.
To Replace:
1. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on its inside surface.
2. Hold oven door so that the top edge of each hinge hanger is
horizontal. Insert hinge hangers into the front frame hinge
slots.
3. Tilt top of door toward range. Slide hinge hangers down onto
front frame support pins. Make sure the hinge hangers are
fully seated and engaged on the support pins.
1. Hinge Hanger
2. Door Frame Hinge
3. Support Pins
Insert the door stop clip with its angular surface at the top of
the frame hinge slot, then push in the bottom of the clip until
its flanges are flush with the front frame.
1. Door Stop Clip
2. Pry door stop clip free and remove from front frame hinge
slot. Take care not to scratch finish.
3. Repeat procedure for other door stop clip.
5. Open the door completely and remove the door removal pins.
Save door removal pins for future use.
6. Close the door.
23