Advertisement
Available languages
Available languages
41007621
JA
Ice Maker
ENG
4/28/03
2:18
PM
Page
14
+
Before Calling for Service, co.,
Check the following
items:
1. Make sure the ice maker is plugged into outlet.
2. Check the outlet for power. Test outlet with a lamp
to make certain outlet has power.
3. Make sure the ice maker's selector switch is in the
ON position (see page 13).
4. Make sure that there is cold water supplied to the
ice maker.
5. Make sure drain plug on bottom of reservoir is
inserted.
6. Make certain unit is level from front to back and
side to side.
7. Make certain that the drain line to the ice maker is
not restricted or kinked.
If you are not able to correct the problem, contact your
dealer or the manufacturer.
Be sure to have the model
number and the serial number handy before you call.
The model and the serial number are located on the
data plate inside on the lower front of the ice maker
cabinet.
Ice maker does
The ice maker is unplugged.
Plug in the ice maker.
not operate.
Breaker is tripped
or fuse is blown.
Reset the breaker or replace fuse.
Ice machine selector switch is in
Set the rocker switch on the grille of the ice
the OFF position,
machine to the ON position.
Water supply is turned off.
Turn on water supply to the ice maker.
Ice maker operates
The ice maker has just been started
Ice produced
when the unit is initially started
but does not produce
and it has been less than 6 hours,
will melt off in the bin. In 6 hours there can be
any ice.
a few cubes in the bin. This is normal
operation.
Typical ice production
cycle can
Check the unit in 24 hours for ice
take up to 1'/2hours. Initial startup
accumulation
in the bin.
cycles can be longer.
The selector switch is in the OFF or
Set the rocker switch on the grille of the ice
CLEAN position,
machine to the ON position.
No water in the reservoir.
Make sure that the reservoir drain plug is
installed. Check the water line to make sure it
is on and that there are no restrictions
or
kinks. Check all filters to make sure they are
not restricted or plugged.
Distributor
tube is restricted.
See Cleaning the Ice Maker System (page 11).
Build up of deposits on evaporator
See Cleaning the Ice Maker System (page 11).
plate.
Condenser fan air flow is restricted.
Make certain the grille in the front of the unit
is free and open for proper air circulation.
Check and clean the condenser
coil by
removing the grille in the front of the unit.
Clean the condenser with a vacuum and brush
attachment.
14
+
Advertisement
Chapters
