Table of Contents
Advertisement
Available languages
Available languages
• When t hecharcoal filter has been excluded, thecharcoal filter
alarm isdisabled.
• The inclusion orexclusion ofthecharcoal filter must b e
selected while thelights and thefanmotor a reOff.
Heat Sensor
The control is equipped with a heat sensor that will turn on the
blower to the highest speed if excessive heat occurs around the
control area.
•
If the blower is On or Off, the blower will automatically
set to
the highest speed. "Auto" will appear in the display to
indicate that the heat sensor has detected excessive heat.
•
When the blower is operating due to excessive heat detected
by the heat sensor, the blower speed cannot be decreased.
•
When the temperature
level on the hood drops to normal, the
blower will return to its setting before the excessive heat was
sensed.
To operate the light:
1. Press the Light button to turn the light on to high.
2. Press the Light button again to turn the light to low.
3. Press the Light button a third time to turn the light off.
The timer can be set from 1 to 60 minutes. The default timer
setting is 10 minutes.
To use the timer:
1. Press the Timer button to enter the timer mode. After
5 seconds the default time will be automatically selected.
2. Press the POWER DECREASE and POWER INCREASE
buttons while the display is flashing (5 seconds) to adjust to
the desired time. Pressing the timer button again or waiting
5 seconds after selecting the desired time will start the timer
countdown.
3. The timer can be canceled at any time by pressing the Timer
button again.
NOTE: During the timer setup, the Power Decrease and Power
Increase buttons are dedicated to the timer. After the timer starts,
the Power Decrease and Power Increase buttons can be used for
other functions.
Power Increase/On
This button is used to turn the fan On or increase the fan speed.
•
The fan will turn On if the Power Increase button is pressed
and the hood was Off.
•
An audible tone will sound when the fan reaches its highest
speed.
Power
Decrease/Off
•
This button is used to turn the fan Off or to decrease the fan
speed.
RANGE HOOD CARE
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Be sure lights are cool before cleaning the hood.
To Remove
Metal Grease Filters
1. Turn off fan and lights. Check that halogen lamp is cool.
2. Remove the filter holder frame and grease filter using a flat-
blade screwdriver to turn the grease filter release screws 90 °
counterclockwise.
Exterior Surfaces
Clean the range hood with a mild detergent and soft cloth. To
avoid damage to the exterior surface, do not use abrasive
cleanser or steel-wool pads.
Metal Grease Filters
The filters should be washed frequently. Place metal filters in
dishwasher or hot detergent solution to clean.
Let filter dry thoroughly
before replacing it.
...................................................................................
S
A
A. Grease filter release screw
B. Filter holder frame
C. Grease filter
10
Advertisement
Table of Contents
