Range Hood Care; Cleaning - Jenn-Air JXL6536HSS Installation Instructions And Use & Care Manual

If Auto Sense is in Sleep Mode, press AUTO once to deactivate
Sleep Mode and turn the Auto button light On. Press AUTO
again to deactivate Auto Sense and turn Off the Auto button
light.
Auto Sense will automatically turn off after 2 hours of no
activation of the Auto Sense system. To reset Auto Sense, press
AUTO.
Manual Vent Functions
Fan Speeds
Low
Press LOW to turn the fan on at Low
speed.
Med Press MED to turn the fan on at Medium
speed.
Hi Press HI to turn the fan on at High speed.
Boost
Press BOOST to turn the fan on at the
highest speed. Boost will automatically turn
Off after 10 minutes and the fan will switch
to High speed.
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
All purpose cleaner.
■
Wipe with damp soft cloth or nonabrasive sponge, and then
■
rinse with clean water and wipe dry.
Metal Grease Filter
1. Open the stainless steel panel. Grasp panel at the front
corners and pull down to disengage the 2 catch pins from
the spring catches. The panel is attached at the rear and will
rotate down.
A
B
A. Metal filters
B. Stainless steel panel

RANGE HOOD CARE

Cleaning

D
C
C. Catch pins (2)
D. Spring catches (2)
Timer
The range hood can be set to turn Off automatically after 15
minutes.
1. Press and hold the desired fan speed button for 2 seconds.
The fan will run on the chosen speed for 15 minutes, and the
fan speed button light will flash continuously.
After 15 minutes, the fan will turn Off automatically.
2. Press the desired fan speed button again while the fan timer
is running to cancel the fan timer.
NOTE: Changing the fan speed or turning Auto Sense On
will also cancel the 15-minute timer.
Light
The range hood has both task and ambient lighting.
To operate the lights:
1. Touch LIGHT once to turn the LED task lights On.
2. Touch LIGHT again to turn LED task lights Off. The ambient
lights will turn On.
3. Touch LIGHT a third time to turn the ambient lights Off.
NOTE: To turn both the task and ambient lights on at the same
time, touch and hold LIGHT for 2 seconds. Touch LIGHT again to
turn the task and ambient lights Off.
2. Remove each filter by pulling the spring release handle and
then pulling down the filter.
A
A. Spring release handle
3. Wash metal filters as needed in dishwasher or hot detergent
solution.
4. Reinstall the filter by making sure the spring release handles
are toward the front. Insert aluminum filter into upper track.
5. Push in spring release handle.
6. Push up on metal filter and release handle to latch into place.
7. Repeat steps 1 through 5 for the other filter.
8. Close the stainless steel panel. Engage the (2) pins in the
spring catches to secure.
Non-Vented (Recirculating) Installation Filters
The charcoal filter is not washable. It should last up to 6 months
with normal use. Replace with Charcoal Filter Kit. See the
"Accessories" section for information on ordering.
To replace charcoal filter:
1. Remove metal grease filter from range hood. See "Metal
Grease Filter" in this section.
2. Bend spring clips away from metal grease filter.
13