Table of Contents
Advertisement
Available languages
Available languages
5. Use UL listed wire connectors
and connect black wires (C)
together.
6. Use UL listed wire connectors
and connect white wires (E)
together.
Electrical Shock Hazard
Electricaly
ground blower.
Connect ground wire to green and yellow ground wire
in terminal
box.
Failure to do so can result in death or electrical
shock.
7. Connect green (or bare) ground wire from home power supply
to yellow-green
ground wire (E) in terminal box using UL listed
wire connectors.
8. Tighten strain relief screw.
9. Install terminal box cover.
10. Check that all light bulbs are secure in their sockets.
11. Reconnect power.
n
C
When using both upper and lower vent covers, push lower cover
down onto hood and lift upper cover to ceiling and install with 2 -
4 x 8 mm screws.
NOTE: For vented installations, upper vent cover may be
reversed to hide slots.
C
Secure the bottom of the duct with 2 - 4 x 8 mm assembly
screws.
i
i
i
1. For non-vented (recirculating)
installations only, install
charcoal filters over grille on blower housing. See the "Range
Hood Care" section.
2. Install metal filters. See the "Range Hood Care" section.
3. Check the operation of the range hood blower and light. See
the "Range Hood Use" section.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
D
,-
-_
i
i
A. Upper vent cover
B. Lower vent cover
C. 4 x 8 mm screws
D. Bracket
A
B
Advertisement
Table of Contents
