LIFESTYLER System CXT Owner's Manual page 5

,
°
=
Slide one end of the 265' Cable (54) onto a
3/8" x 2' Bolt (9). (The 265" Cable is the long
Cable that has an eyelet on one end, and is
threaded on the other end.) Slide a Cable
Trap (3) and a Small Pulley (1) onto the Bolt.
Insert the Bolt through the indicated bracket
on the Press Frame (20) and tighten a 3/8'
Nylock Nut (4) onto the Bolt. IMPORTANT:
As you attach each of the Pulleys In
assembly steps 3-43, be careful not to
overUghten the Nylock Nuts.
Press two I 3/4" Round Caps (67) into the
upper end of the Bench Press Arm (21).
Insert a Handle (76) into one side of the Bench
Press Arm (21). Tum the Handle so the small
hole near the end of the Handle is aligned
with the hole in the Bench Press Arm. Attach
the Handle with a 3/4" Screw (75).
Attach a Handle (76) to the other side of the
Bench Press Arm (21) in the same manner.
Wet both Handles (76) with soapy water.
Slide a Grip (46) onto each Handle.
I1_,/ ,t-'J I1(., • Irl_._[l_ ' k/O_/ _UU/ UI ILU UI I€ €1 IU UI
the 1/2" x 10" Axle (58). Apply a small
amount of grease to the Axle. Align the lower
end of the Bench Press Arm (21) with the
indicated tube on the Base (19). Insert the
Axle through the Bench Press Arm and the
Base. While holding one hammer against the
1/2" Plastic Cap (68) on the Axle, tap another
1/2" Plastic Cap (68) onto the Axle.
Press the two 1 3/4" Square Caps (64) into
the Leg Press Lever (22).
Press two 3/4" Bushings (18) into the indicat-
ed bracket on the Base (19).
Tap a 3/4" Plastic Cap (69) onto one end of the
3/4" x 3 1/2" Axle (59). Apply a small amount of
grease to the Axle. Align the lower end of the
Leg Press Lever (22) with the bracket on the
Base (19). Insert the Axle through the Leg
Press Lever and the 3/4" Bushings (18) in the
Base. While holding one hammer against the
3/4' Plastic Cap (69) on the Axle, tap another
3/4" Plastic Cap (69) onto the Axle.
20
4
67
67
Grease
58
5
64
69
Grease