LIFESTYLER System CXT Owner's Manual page 13

30. Insert the Clevis Pin (60) through one of the
three holes in the Weight Upright (31). Insert
the Hairpin Cotter (61) through the Clevis Pin.
Note: The Clevis Pin is very similar to the Leg
Lever Axle (not shown). If the Hairpin Cotter
does not fit, then you have mistaken the Leg
Lever Axle for the Clevis Pin.
Press a 1 1/2" Square Cap (63) into the Seat
Bracket (30).
Attach a Seat (39) to the Seat Bracket (30)
with two 1/4" x 3/4" Bolts (6). Slide the Seat
Bracket onto the Clevis Pin (60). WARNING"
Make sure that the Seat Bracket Is fully
seated on the Clevis Pin.
31. Press one 2" Square Cap (65) and three
1 1/2" Square Caps (63) into the Butterfly
Frame (24).
Slide the Butterfly Frame (24) onto the two
indicated 3/8" x 2 1/2" Carriage Bolts (14) in
the Base (19). Attach the Butterfly Frame with
two 3/8" Lock Washers (15) and 3/8" Nuts
(5). Make sure that the heads of the Carriage
Bolts are flush against the Base.
32. Align the upper end of the Leg Lever (28)
with the indicated hole in the Butterfly Frame
(24). Insert the Leg Lever Axle (56) through
the Leg Lever and the Butterfly Frame. While
holding one hammer against the Leg Lever
Axle, tap the 1/2" Hat Cap (55) onto the Leg
Lever Axle.
33. Slide a Cable Trap (3) and a Small Pulley (1)
onto a 3/8" x 4" Bolt (12). Route the 258"
Cable (53) up around the Small Pulley. Make
sure that the Cable is between the Cable
Trap and the Small Pulley.
Insert the 3/8" x 4" Bolt (12) through the indi-
cated hole in the Butterfly Frame (24).
Tighten a 3/8" Nylock Nut (4) onto the Bolt.
30
/
6
63 J_ 24
15
IIIrlll
24
53
4 24
I/I
3
13