LIFESTYLER System CXT Owner's Manual page 16

41.
42.
Insert a 3/8" x 2 3/4" Bolt (10) through the
indicated hole in the Leg Lever (28).
Slide a Small Pulley (1) and a Cable Trap (3)
onto the 3/8" x 2 3/4" Bolt (10). Route the
258" Cable (53) up around the Small Pulley.
Make sure that the Cable is between the
Cable Trap and the Small Pulley. Tighten a
3/8" Nylock Nut (4) onto the Bolt.
Insert a 3/8" x 4" Bolt (12) through the tube
on the Butterfly Frame (24).
Slide a Small Pulley (1) and a Cable Trap (3)
onto the 3/8" x 4" Bolt (12). Route the 258"
Cable (53) up around the Small Pulley. Make
sure that the Cable is between the Cable
Trap and the Small Pulley. Tighten a 3/8"
Nylock Nut (4) onto the Bolt.
16
43. Route the 258" Cable (53) over a Small Pulley
(1). Attach the Small Pulley to the UDDer end
of the Butterfly Frame (24) with a 3/8" x 3 1/2"
Bolt (11) and 3/8" Nylock Nut (4). Make sure
that the Cable is between the indicated pin
and the Small Pulley.
44. Attach a Seat (39) to the Butterfly
Frame (24)
with two 1/4" x 3/4" Bolts (6).
Snap the plastic pin on the lower end of the
Large Backrest (37) into the lower hole in the
Butterfly Frame (24). Attach the upper end of
the Large Backrest to the Frame with a 1/4" x
2 1/2" Bolt (7).
24
J