LIFESTYLER System CXT Owner's Manual page 17

45.
46.
Insert one Pad Tube (71) through the
Butterfly Frame (24), and one Pad Tube
through the Leg Lever (28).
Wet the ends of the Pad Tubes (71) with
soapy water. Slide the four Small Pads (29)
onto the Pad Tubes.
Press two Weight Sleeves (72) into each of
the twenty Weights (40).
Slide ten Weights (40) onto each pair of
Weight Guides (34) by tipping the Weights
as shown. Make sure that all of the
Weights are turned so the pin grooves
are downward, and are on the Indicated
sides or the system will be damaged.
Press a Weight Center (74) into the top
Weight (40) on each stack of Weights.
Insert the two Weight Tubes (35) into the
stacks of Weights (40).
45
46
29
_rooves
\
47.
48.
Make sure that all parts are properly tightened. Adjust the position of each cable trap so that
when the compact training system Is used the cables will not rub against the edges of the
cable trap. The use of all remaining parts will be explained in the USING THE COMPACT TRAIN-
ING SYSTEM section on pages 21 and 22 of this owner's manual.
Before using the compact training system, test the cables and pulleys. Pull the end of each cable a
few times to make sure that the cable moves smoothly over the pulleys. Move the butterfly arms,
leg lever, military press arm, bench press arm and leg press plate a few times. If one of the cables
does not move smoothly, locate and correct the problem before using the compact training system.
See the CABLE DIAGRAMS on pages 19 and 20 of this owner's manual to see how each cable
should be routed. IMPORTANT: If the cables are not properly routed, they may be damaged
when used with heavy weight.
17