Electrical Connections - Hotpoint RA720 Owner's Manual And Installation Instructions

Installation Instructions
ELECTRICAL CONNECTIONS
(CONT.)
3-WIRE CONDUIT INSTALLATION
Loosen the 3 lower terminal screws from
the terminal block. Insert the center bare
wire (white/neutral) tip through the bottom
center terminal block opening. On certain
models, the wire will need to be inserted
through the ground strap opening and then
into the bottom center block opening. Insert
the two side bare wire tips into the lower
left and the lower right terminal block
openings. Tighten the screws until the wire
is firmly secure (approximately 20 inch-lbs.),
NOTE: ALUMINUM WIRING:
Aluminum building wire may be used
but it must be rated for the correct
amperage and voltage to make
connection. Connect wires according
to this Step 6 or Step 7 depending on
number of wires.
Terminal
block
Wire tips
Bracket
Conduit
Wire used, location and enclosure
of splices, etc., must conform to good
wiring practices and local codes.
[] Skip to Step 8 and proceed with the
installation.
[-_ 4-WIRE CONDUIT INSTALLATION
[]
[]
Loosen the three lower terminal screws
from the terminal block. Remove the ground
screw and ground plate and retain them.
Cut and discard the ground strap. DO NOT
DISCARD ANY SCREWS.
Insert the ground bare wire tip between the
range frame and the ground plate (removed
earlier) and secure it in place with the ground
screw (removed earlier), Insert the bare wire
(white/neutral) tip through the bottom center
of the terminal block opening. Insert the two
side bare wire tips into the lower left and the
lower right terminal block openings. Tighten
the screws until the wire is firmly secure
(approximately 20 inch-lbs.).
Before _/____ Greed strap
Terminal_blOCkcut and discard J_'_Y_*_ L__S:_I_tJ_ _ or
the ground strap Neutral ter_ " minal
After _/_
Terminal //__r_t_
block /
(_ _'_ t__1_
Ground
Wire tips _j_ _gat_ riding
Gcr°Un d-----'___B ra c ke t
[]
Wire used, location and enclosure
of splices, etc., must conform to good
wiring practices and local codes.
Proceed to Step 8.
18
[-_ REPLACE THE WIRE COVER
Replace the wire cover on the range back
by sliding its two lower retaining tabs into
the slots and replacing the screw removed
earlier. Make sure that no wires are pinched
between the cover and the range back.