O_En - Hotpoint RA720 Owner's Manual And Installation Instructions

Usingthe oven.
The OVEN TEMP knob is located on the control panel on the front of the range.
OVEN @ TEMP
Oven TemperatureControl
To use the oven, simply mrn the knob
to the desired cooking temi)eramres ,
which are marked in 25°F increments
on the dial. OVEN TEMP maintains the
teinperature
you set, fl'oin 200°1:t(> BROIL.
TheOven Cyc/i)_g bghtg/owsuntil theoven
reaches y ourselectedtemperature, thengoesoff
andon with theovenunit(s) dun?)g c ookl?)g.
Bum
Oven Shelves
The shelves are designed Mth stop-locl<s
so when placed correctly on the shelf
sui)ports, they will stop beflwe coming
complemly Otlt of the oven and will not
tilt when um are removing fl)od ti'om
them or placing fi)od on them.
When plating cookware on a shell, pull
the shelf out to the bump on the shelf
sui)port. Place the cookware on the
shelf, then slide the shelf back into the
oven. This will eliminate reaching into
the hot oven.
To remove the shelves from the oven, pull
them toward you, tilt fl'ont end Ul)ward
and pull them Otlt.
Toreplace,
place shelf on shelf suI)port
with stoI>locl<s (curved exmnsion of
shelf') fi_dng up and toward back of oven.
Tilt up ti'ont and push shelf toward back
of oven until it goes past the bum I) on
the shelf supI)ort. Then lower ti'ont of
shelf and push it all the way back.
1
Theovenhas 4shelf positions.
OvenShelf Positions
The oven has four shelf SUl)ports_
(bottom), B, C and O (top).
Shelf positions fl)r cooking are suggested
on Baking and Roasting pages.
Use of Aluminum Foil
• It desired, a sheet ol
ahlI/lintlIll
toil may be used on the floor of the
oven under the bake element.
Be certain foil does not touch bake
element _uminum
fi)il used in this
way may slightly atti_ct the browning
of some foods. Change fi)il when it
becomes soiled.
• DO NOT place a sheet of aluminum
foil on the shel£ To do so may result
in improperly cooked fi>ods, damage
to oven finish and increase in heat
on outside surfaces of the oven.
You may use ahmfinum fi)il to line the
broiler pan and broiler grid. However;
you Inust n/old the fi)il tightly to the
grid and cut slits in it just like the grid.