Advertisement
How to assemble
A. Put handle together
Remove
cardboard
from the end
of handle
sections.
Slide the two handle
sections
to-
gether.
Check
to see that cord
storage
hooks are on the same
side of handle.
Insert bolt through
small holes and secure with nut.
Tighten
nut with screwdriver.
If the nut and bolt will not assem-
ble as shown
in the illustration,
the holes in the handle are not
lined up correctly.
B. Attach handle to
the cleaner
Unscrew nut and remove bolt
and plate from handle bail.
Take assembled
handle and place
so that the socket
holes in the
bottom
of the handle
are directly
in line with the electrical
prongs.
Position the handle so that the
ON-OFF
switch is to the rear of
the cleaner.
Push down until handle is secure-
ly in place. Insert bolt into small
hole in front of handle.
Replace
plate on back of handle,
by inserting
projection
on plate
into lower hole on handle.
Tabs
on handle
bail will fit into notches
on plate. Position
nut on bolt and
tighten
with
screwdriver.
Advertisement
