Advertisement
Select the adjustment for the carpet pile height according to the chart below.
Low
for low pile and kitchen carpet
Normal
for carpet with normal
pile height and for removing
loose dirt
from hard surface floors
.=
High
for carpet with normal
pile height but thicker density;
if th'lr"
cleaner
is difficult
to push at "Normal",
move the lever to the
"High"
position.
Shag
for very long or shag pile carpet
Note: If the "Low" setting is used when cleaning
normal or shag pile carpet,
there is an increase in the belt load and pushing effort is greatly increased.
Cleaning lightweight
flexible rugs
Lightweight flexible
rugs used on
hard surface floors
in entrances,
bathrooms,
etc. should
be clean-
ed by the following
method.
Stand on one end of the rug and move the cleaner toward the other end
or edge. Before reaching the other end, push down on the handle. This
will lift up the nozzle (front of cleaner) and will prevent the rug from
clinging to the cleaner. Continue to lift up the nozzle so that when you
have reached the edge, it is completely off the rug. Move the cleaner back
to start again and lower the nozzle, using only forward strokes.
Special features
Carrying handle
Your cleaner
has a convenient
carrying
handle
located
on the
underside
of the handle bail.
Edge cleaning
This feature improves the cleaning
of carpet edges near baseboards
and solid furniture.
Dust and lint
tend to collect along these edges.
The cleaner bottom plate has been
designed with a passageway
for
dirt to enter the nozzle from the
side to increase cleaning ability of
edges. From the right or left side,
slowly guide the cleaner parallel to
the edge of the carpet.
Advertisement
