If You Have A Problem - Hoover concept two U4217 Owner's Manual

Reusable filter
How to clean filter
Disconnect cleaner from electri-
cal outlet.
The filter protects the motor from dirt particles. Brush dirt from filter
when emptying dust cup. If a significant reduction in pick-up is observed,
the filter may be washed in warm water. Filter must be completely dry
before replacing it in cleaner. Under normal operating conditions, a new
filter may never be needed if care is taken not to pick up oily debris or
sharp objects.
If you have a problem
These appliances were inspected thoroughly and were in good operating
condition when shipped from the factory. If a minor problem develops, it
usually can be remedied quite easily when the cause is identified. Accord-
ingly, this check list is provided for your convenience.
Problem Possible cause Possible solution
Cleaner 1. Cord not firmly plugged 1. Plug cord in firmly.
won't in.
run 2. No voltage in wall plug. 2. Check fuse or breaker.
3. Blown fuse/tripped 3. Replace fuse/reset
breaker, breaker.
1. Broken or worn agitator 1. Replace belt.
belt.
2. Agitator brushes worn.
3. Bag full.
4. Obstruction in cleaner.
Upright
cleaner
won't
pick up
Hand-
held
cleaner
won't
pick up
Dirt fall-
ing from
Hand-
held
cleaner
5. Bag not opening.
2. Replace brushes.
3. Change throw away bag.
4. Cleaner pivoting dirt duct
and/or dirt tube.
5. Check for firm bag
connection.
1. Dust cup full. 1.
2. Nozzle, or attachments 2.
clogged.
3. Filter clogged. 3.
1. Inner nozzle flap clogged 1.
or damaged.
Empty dust cup.
Remove obstruction.
Empty dust cup and clean
filter.
Remove obstruction;
replace flap if necessary.
24