Hoover concept two U4217 Owner's Manual page 15

The headlight
Disconnect cleaner from electri-
cal outlet,
This cleaner uses two 12 volt,
wedge base type 912 bulbs.
1. Lower the handle until the
cleaner is positioned with the bag
; flat on the floor.
2. Use screwdriver to lift lens,
Place screwdriver in one of the
two slots provided at the top
edge under ridge of lens as
shown. Turn screwdriver to
loosen lens.
3, Lift out lens,
5. Replace lens by inserting plastic
projections into openings in
cleaner.
4. Remove bulbs by pulling
straight out of sockets. Replace by
pushing each bulb straight into
the socket until it locks in place.
(Excessive force is not required.)
6. Insert screwdriver into one of
the slots at the top of the head-
light lens. Snap lens into place
by pushing down on handle of
screwdriver while pressing on
lens.
14