GE Profile PV976 Owner's Manual And Installation Instructions page 21

Installation Instructions
F6-I CONNECT ELECTRICAL
Verifg that power is turned off at the source.
-& WARNING:
,f house wiringisnot 2-wire
with o ground wire, o ground must be provided
by the installer, When house wiringis aluminum,
be sure to use U,L, approved anti-oxidant c ompound
and aluminum4o-copper connectors,
• Remove the 6 screws on the junction box cover
and the knockout on the top left side.
Kn° ck° ut ---..._ ____-, I
JunctionS> f ........... \ X
• Secure the house wiring to the junction box
with a strain relief.
I -T
i 'f
• Connect the white lead to the branch circuit white lead.
• Connect the black lead to the branch circuit black lead.
• Connect the green/yellow lead to the branch
circuit green lead or bare ground lead.
• Secure all the connections with wire nuts on each
electrical connector.
• Push the wires into the junction box and replace
the cover. Be sure the wires ore not pinched.
• Secure the junction box cover with the 6 original
screws.
I-_ INSTALL DUCT COVERS
• Remove protective plastic
covering.
• Assemble duct covers
according to application.
NOTE: The upper duct cover
has vent holes on one end
intended for use when the hood
is installed for recirculating
purposes. Be sure the vented
end is at the top; the vent holes
will be visible in this installation.
Slide the upper duct cover into
the folded ends of the lower duct cover.
Moues
Ventholes
L
I.
• Place the decorative duct covers on top of the hood.
...... Duct cover
Upper duct -_ support bracket
cover
Lower duct
cover
Lower duct
coverseat
Duct cover
attachment tabs
• Extend the inner duct cover upward to the ceiling
bracket.
• Secure with 2 screws to the duct cover bracket.
• Remove the packing material from the filter opening.
• Locate the screw holes on the inside front edge
of the opening. Install 2 screws to secure the lower
duct cover to the hood.
21