GE Profile PV976 Owner's Manual And Installation Instructions page 20

Installation Instructions
INSTALLATION--RECI RCU LATI NG
MOUNT THE HOOD
.4,WARNING: 2people are required tolift
and position the hood onto the mounting screws.
• Lift the hood onto the mounting screws.
• If using a wall fastener, make sure the washer
is in front of the flange and not behind it. Check
with a level before tightening screws.
• Install lower screws to pull the hood tight against
the wall.
Tighten
Bottom Install
screw screws
location
[-_ SIZE AND CUT DUCT PIECE
• Measure from the bottom of the air deflector
to the top of the hood as shown. Reduce that
dimension bg 1" to facilitate installation.
The duct will cover and overlap the deflector
and the exhaust outlet in the hood.
• Remove the air deflector from the duct cover
bracket.
Measure Duct
length length
• Cut the duct piece to size and slip onto the bottom
of the deflector.
• Place the assembled deflector and duct over
the exhaust outlet.
• Hold the assemblg against the duct bracket.
• Drive 2 screws into each side of the bottom
of the deflector and into the bracket.
• Use duct tape to seal duct to the deflector
and at the exhaust outlet.
Deflector
2O