Using The Clockand Timer - GE JMP31 Owner's Manual

Usingthe clock and timer.
Make sure flTeclock is set to the
correct time of da_
ToSet the Clock
The clock must be set to the correct time
of da)for the autonmfic oxen timing
flmctions to work properly. The time of
day cannot be chanoed durh_g a timed
baking or self:cleaning cycle,
[] Press the
CLOCKpad.
[] Press the INCREASE or DECREASE
pads.
[] Press the
STARTpad.
i; ¸
] TIMER ]
The timer is a mflTutetimer onl_
The timer does not control oven
operations. The maximum
settilTg
on the timer is 9 hours and 59
minutes.
To Set the Timer
[] Pressthe KITCHEN TIMERON/OFF
pad.
[] Press the
INCREASE or DECREASE
pads tmtil the am ount ot tim e )ou
want shows in the display.
lfxou make a mistake press the
KITCHENTIMERON/OFF pad and
begin again.
[]
Press the STARTpad.
[] _hen the timer reaches :00, the
control will beep 3 times followed 1)_
one beep eve_w 6 seconds until the
KITCHEN TIMER ON/OFF pad is
pressed.
The&second tonecan be cance/edby following
the steps in the Specialfeatures of your oven
control section under Tonesat the Endof a
TimedCycle.
ToReset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the KITCHEN TIMER ON/OFF pad, then
press the INCREASE or DECREASEpads
until the time you want appea_
in the
display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the KITCHEN TIMER
ON/OFF
pad
and then pressing the
INCREASE or
DECREASE pads
to enter the new time
Veil want.
ToCancel the Timer
Pressthe KITCHEN TIMERON/OFF pad
twice.
Power Outage
_Mter a power outage, when power is
restored the display will flash and time
shown will no longer be correct--for
example,after a 5-minute power interruption
the dock wi// be 5 minutes slow
The display flashes until the clock is reset.
MI other flmctions that were in operation
when the power went out will have to be
programmed again.
14